Authors: H Dhaliwal
By attaching multiple massive anti- gravity wheel type structures to the rocket we may achieve a less apparent weight for the rocket, allowing it to lift easier. Instead of a wheel, a hollow saucer like pod shall be used, attached to a bar, which connects to the rocket. There are multiple anti gravity saucers attached to the rocket in a symmetric fashion connecting to a point at the rocket. These saucers will carry water, fuel or cargo which is minused from the rocket and added to the saucer. Displacing the weight from the rocket and into the saucers will ensure no extra weight is added. These saucers will be spun up extremely fast from the ground via motors, storing energy in them. The motors are ground based at the lift off site and will decouple from the saucers on lift off. The torque induced gyroscopic precession of these spinning saucers will decrease the apparent weight of the rocket as the rocket raises, allowing the thrust to make the rocket raise easier. The fuel in the rocket tank will not be filled 100%. Perhaps it will be filled 50%. The other 50% of the fuel is displaced and divided amongst the saucers and stored in them. As the rockets main fuel tank level lowers during mid flight, the fuel in the saucers can be pumped into the tank of the rocket for continued use. These saucers spin rate will be slowed down as the rocket raises, allowing easier transfer of fuel. When the fuel in the saucer tanks is depleted, the anti gravity saucer arms can be disconnected from the rocket and the saucers shall fall back towards earth. Instead of fuel, water can also be stored in these saucers for long term human missions to mars. The water can be frozen solid in the saucer tanks to keep the saucers cool as they ascend, and the ice will melt as the rocket ascends. The water tank in the rocket will be empty on lift off. But will be refilled in the same manner as above after reaching a certain altitude. Cargo that can withstand centrifugal forces can also be stored, such as food, or metal equipment. This equipment can then be reintroduced to the rocket by moving the saucer pods to the rocket. The whole rocket structure can be on a platform that makes the rocket setup rotate just before liftoff so the saucer wheels can start their gyroscopic precession. Or mechanism can be built into the saucer arms to push the saucer outward a bit to start the gyroscopic precession. Or such a setup may not be needed as a rocket rotates by itself usually as it ascends which will efficiently create the needed gyroscopic precession.
Comments: 4 Pages.
[v1] 2017-02-18 22:26:45
Unique-IP document downloads: 128 times
Vixra.org is a pre-print repository rather than a journal. Articles hosted may not yet have been verified by peer-review and should be treated as preliminary. In particular, anything that appears to include financial or legal advice or proposed medical treatments should be treated with due caution. Vixra.org will not be responsible for any consequences of actions that result from any form of use of any documents on this website.
Add your own feedback and questions here:
You are equally welcome to be positive or negative about any paper but please be polite. If you are being critical you must mention at least one specific error, otherwise your comment will be deleted as unhelpful.