Thermodynamics and Energy


Development of a Small 50W Class Stirling Engine

Authors: UnChol Ri, GumChol Ri, ChangIl Ri, YongHuan Kim, SongJin Ri

In order to develop a compact and low cost Stirling engine, a gamma type Stirling engine with simple moving-tube-type heat exchangers and a rhombic mechanism was developed. Its target shaft power is 50 W at engine speed of 4000 rpm and mean pressure of 0.8 MPa using helium as working gas. This paper describes the outline of the engine design and the performance test. The test was done without load, using air in atmospheric condition. Also, a mechanical loss measurement was done in highly pressurized condition, in which the engine was driven by a motor compulsory. Then, methods to get higher performance were considered based on the comparison of experimental and calculated results. The results indicate that a higher performance heat exchanger and decreasing of mechanical loss are needed for the attainment of the target performance.

Comments: 7 Pages.

Download: PDF

Submission history

[v1] 2019-01-21 07:09:08

Unique-IP document downloads: 0 times is a pre-print repository rather than a journal. Articles hosted may not yet have been verified by peer-review and should be treated as preliminary. In particular, anything that appears to include financial or legal advice or proposed medical treatments should be treated with due caution. will not be responsible for any consequences of actions that result from any form of use of any documents on this website.

Add your own feedback and questions here:
You are equally welcome to be positive or negative about any paper but please be polite. If you are being critical you must mention at least one specific error, otherwise your comment will be deleted as unhelpful.

comments powered by Disqus