The methylsulfonylmethane (MSM) is an organosulfur compound having sulfonyl functional group. It is occurred naturally in some primitive plants and used in disease related to chronic pain, inflammation, and arthritis. This study was attempted to evaluate the impact of biofield energy treatment on the physical, thermal, and spectral properties of MSM. The study was performed in two groups viz. the control group was remained as untreated, while the treated group was subjected to Mr. Trivedi’s biofield energy treatment. After that, both the control and treated samples were analyzed using surface area analyzer, X-ray diffraction (XRD), thermogravimetric analysisderivative thermogravimetry (TGA-DTG), differential scanning calorimetry (DSC), and Fourier transform infrared (FTIR) spectroscopy. The surface area analysis exhibited a significant decrease in the surface area of treated sample by 22.96% as compared to the control. The XRD analysis showed the significant increase in average crystallite size by 49.20% in the treated sample with respect to the control. The DSC analysis showed the significant increase (67.20%) in latent heat of fusion of treated sample with respect to the control. The TGA analysis showed the onset temperature of thermal degradation at 170°C in the control sample that was slightly decreased to 168.05°C after biofield treatment. Moreover, the Tmax (maximum thermal degradation temperature) was also decreased slightly from 186.66°C (control) to 183.38°C (treated). This indicated the early phase of vaporization in treated sample as compared to the control. The FT-IR spectroscopic study exhibited the alteration in wavenumber of S=O group that suggests the effect of biofield treatment on force constant and bond strength of MSM molecules.
Carbazole is a class of phytochemical associated with cancer prevention. It attracted a significant interest in recent time for their usefulness in synthetic heterocyclic chemistry, analytical chemistry and pharmacology. The aim of the study was to evaluate the impact of biofield energy treatment on carbazole by various analytical methods. The study was performed in two groups i.e. control and treatment. The treatment group was subjected to Mr. Trivedi’s biofield treatment. Subsequently, both the samples were characterized with respect to physical and structural properties using X-ray diffraction (XRD), differential scanning calorimetry (DSC), thermogravimetric analysis (TGA), Fourier transform infrared (FT-IR), gas chromatography-mass spectrometry (GC-MS), laser particle size analyzer, and surface area analyzer. The XRD study revealed that the crystallite size of treated carbazole was decreased significantly with 37.5% as compared to the control. In addition, the intensity of XRD peaks was slightly decreased as compared to the control. The latent heat of fusion (ΔH) of treated carbazole was substantially increased by 253.6% as compared to the control. Maximum degradation temperature (Tmax) of treated carbazole was increased by 41.46°C as compared to the control (211.93°C to 253.39°C). FT-IR spectra showed similar stretching frequencies in both control and treated carbazole samples. GC-MS data revealed that isotopic abundance ratio of either 13C/12C or 15N/14N or 2H/1H (PM+1/PM) of treated carbazole was significantly increased up to 278.59%. Particle size analysis showed substantial decrease in average particle size (d50) and d90 of the treated carbazole by 25.24% and 4.31%, respectively as compared to the control. The surface area analysis exhibited an increase in the surface area of treated sample by 4.8% as compared to the control. Overall, the experimental results suggest that biofield energy treatment has significant effect on physical, spectral and thermal properties of carbazole.
Authors: Fu Yuhua
Comments: 5 Pages.
As No.1 of comparative chemistry series papers, running the comparative studies between the element periodic table and the concepts of “fractal in fractal”, “sub-library in library”, and the like, and reaching the concept of “tables in element periodic table”. Then, some special forms of “tables in element periodic table” are discussed. Also pointing out that in the big data analysis of chemical elements, “tables in element periodic table” will have a good prospect.
High performance liquid chromatography tandem
mass spectrometry (HPLC-MS/MS) has been successfully applied to cannabis plant extracts in order to identify cannabinoid compounds after their quantitative isolation by means of supercritical fluid extraction (SFE). MS conditions were optimized by means of a central composite design (CCD) approach, and the analysis method was fully validated. Six major cannabinoids [tetrahydrocannabinolic acid (THCA), tetrahydrocannabinol (THC), cannabidiol (CBD), tetrahydrocannabivarin (THCV), cannabigerol (CBG), and
cannabinol (CBN)] were quantified (RSD < 10%), and seven more cannabinoids were identified and verified by means of a liquid chromatograph coupled to a quadrupole-time-of-flight (Q-ToF) detector. Finally, based on the distribution of the analyzed cannabinoids in 30 Cannabis sativa L. plant varieties and the principal component analysis (PCA) of the resulting data, a clear difference was observed between outdoor and indoor grown plants, which was attributed to a higher concentration of THC, CBN, and CBD in outdoor grown plants.
In this study, supercritical fluid extraction has been successfully applied to a sequential fractionation of fatty acids and polyphenols from wine wastes (2 different vitis vinifera grapes). To this aim, in a 1st step just fatty acids were extracted and in a 2nd one the polyphenols. The variables that affected to the extraction efficiency were separately optimized in both steps following an experimental design approach. The effect of extraction temperature flow, pressure, and time were thoroughly evaluated for the extraction of fatty acids, whereas the addition of methanol was also considered in the case of the polyphenols extraction. A quantitative extraction with high efficiency was achieved at a very short time and low temperatures. Concerning quantification, fatty acids were determined by means of gas chromatography coupled to mass spectrometry after a derivatization step, whereas the polyphenols were analyzed by means of high performance liquid chromatography coupled to tandem mass spectrometry and the Folin–Ciocalteu method.
Authors: Mahmoud Mohsen Ali Alsayes
Comments: 24 Pages.
Despite its significant importance in the economy growth, concrete industry faces several environmental and economic challenges like the emissions of toxic gases during production and high prices of the products, respectively. Consequently, the project aims to produce an alternative solution to the conventional concrete by following the design requirements of low cost, high efficiency and through recycling the fly ash, another industrial pollutant. The idea depends on mixing the fly ash with a liquid alkaline activator, under certain conditions to produce solidified concrete that has proven efficiency after testing. Finally, the mixture, put for 24 hours in 75℃ in dry oven to solidify, has shown the best results. In conclusion it can be easily deduced that such cement is an eco-friendly cheap alternative to conventional concrete; in addition to getting rid of another pollutant.
The objective of the current experiment was to evaluate the effect of biofield energy treatment on the isotopic abundance ratio of PM+1/PM (2H/1H or 13C/12C or 15N/14N) in indole using the gas chromatography-mass spectrometry (GC-MS). The sample of organic compound indole was divided into two parts - one part was designated as a control sample (untreated), and another part was considered as biofield energy treated sample, which was subjected to Mr. Trivedi’s biofield energy treatment (The Trivedi Effect®). The biofield energy treated indole sample was analyzed at different time intervals and were symbolized as T1, T2, T3, and T4 to understand the effect of the biofield energy on isotopic abundance ratio with respect to the time. From the GC-MS spectra, the presence of the molecular ion peak C8H7N+ (m/z 117) along with major fragmented peaks C7H6+ (m/z 90), C7H5+ (m/z 89), C5H3+ (m/z 63), C4H2+ (m/z 50), C3H3+ (m/z 39), and C2H4 (m/z 28) were observed in both control and biofield treated samples. Only, the relative peak intensities of the fragmented ions in the biofield treated indole was notably changed as compared to the control sample with respect to the time. The isotopic abundance ratio analysis of indole using GC-MS revealed that the isotopic abundance ratio of PM+1/PM in the biofield energy treated indole at T1 and T2 was significantly decreased by 44.28 and 28.18% as compared to the control sample. On the contrary, the isotopic abundance ratio of PM+1/PM in the biofield energy treated sample at T3 and T4, was significantly increased by 41.22 and 180.88%, respectively as compared to the control sample. Overall, the isotopic abundance ratio of PM+1/PM (2H/1H or 13C/12C or 15N/14N) was significantly altered in the biofield energy treated indole as compared to the control with respect to the time. The biofield treated indole with the altered isotopic abundance ratio might have altered the physicochemical properties and rate of reaction. This biofield energy treated indole might be more useful as a chemical intermediate in the production of pharmaceuticals, chemicals, plastics, dyes, and perfumes.